Call our team (07) 5404 9354

Where is my mains water valve and how do I turn it off?

The meter stop tap is commonly near the property boundary. Turn a clearly identified handle clockwise without force, then check whether a cold tap stops flowing.

On Unitywater properties, the water meter and stop tap are commonly near the property boundary or in a ground-level meter box. Locations vary in units and older buildings. Do not operate a locked, sealed or unidentified valve.

Turn off an accessible stop tap

  1. Stay out of pooled water and away from wet electrical equipment.
  2. Locate the meter stop tap and confirm it belongs to your property. In a complex, it may be a shared or private sub-meter.
  3. Turn a clearly identified lever or tap handle clockwise by hand. It should not need excessive force.
  4. Open an accessible cold tap to check whether flow stops. A little water may remain in the pipework.

Unitywater’s stop-tap guidance says to contact them if you cannot turn off the stop tap on their meter. For a sub-meter in a complex, contact the body corporate or building manager. Read how to identify a local tap isolation valve if only one fixture is affected.

If the leak continues

Do not use pliers, an extension bar or force on a stuck or damaged valve. If water is gushing, the meter box is flooding or there is a safety hazard in the Unitywater area, call Unitywater faults and emergencies on 1300 086 489. A leak in private plumbing still needs a licensed plumber.

If a local valve cannot be operated safely, see what to do when a water valve will not close. For urgent private-side leaks, contact our Sunshine Coast emergency plumbing team.