Call our team (07) 5404 9354

When should a dripping hot-water relief valve be checked?

Relief-valve discharge can be part of normal heating on some models, but a persistent drip needs professional attention.

A small release from a storage heater’s relief-valve drain can occur during heating, but the normal pattern depends on the model. A steady or continuing leak should be checked by a licensed plumber.

The temperature-pressure relief valve is a safety component that can discharge water to limit excessive cylinder temperature or pressure. It is one of the parts that make up a hot-water system. Manufacturer instructions say some water can discharge as the contents heat and expand. Some systems also have an expansion-control valve on the cold-water supply.

What discharge can be normal?

Some intermittent discharge from a valve drain while the heater is heating may be expected. Rheem’s owner guides describe this behaviour for their specified storage models, while Thermann gives similar guidance for its storage range.

These manuals do not establish one acceptable amount for every heater. Check the instructions for your model rather than comparing the drip with a general volume or another household’s system.

When should you arrange an inspection?

Contact a plumber if water continues to run, the discharge increases or changes, or you are unsure which outlet is releasing water. A drip alone cannot identify the cause or confirm that a valve is working correctly.

Keep clear of the discharge point because water from a relief line can be hot. Heavy discharge, escaping steam or signs of overheating warrant prompt professional help; stay clear.

Do not block, cap or disconnect the drain, and do not adjust the valve. Follow the appliance manual and have persistent leakage assessed.

If water is spreading inside the home, see what to do about a hot-water leak. For a local assessment, use the hot-water service page. A plumber can identify the system and check the valve and other components.