Call our team (07) 5404 9354

What should I do if my hot water system is leaking?

First keep clear of hot water and electrical hazards. A small discharge during heating can be normal, but continuous flow, a tank leak or water near wiring needs prompt attention.

If a hot water system is leaking, keep people away from the unit, hot discharge and pooled water. Water can scald, and a wet appliance or nearby switchboard can be dangerous. Do not remove covers, tighten fittings or try to drain the cylinder.

Make the area safe first

To make a leaking hot water unit safe, close the cold-water isolation valve at the tank (or shut off the main water meter stop tap) and switch off the hot water circuit breaker at the switchboard if it is dry and safe to access. For a gas water heater, turn off the gas isolation valve if safe, and call our licensed emergency plumbers on (07) 5404 9354.

Only close a clearly identified water or energy isolation control if it is dry, accessible and safe to operate. Do not cross water to reach a switch, force a valve or approach a gas appliance that may be leaking. If you cannot isolate safely, leave it to emergency responders or a licensed tradesperson.

Is water from the relief pipe always a fault?

Some water may discharge from a temperature-pressure relief or expansion-control valve while a storage heater warms. Rheem’s guide for the specified electric domestic models says continuous leakage or heavy flow can indicate a problem. The amount and correct response depend on the model and installation, so do not block or cap a discharge pipe. Water from a leaking tank, a sudden increase in flow, or a leak that continues between heating cycles needs prompt plumbing assessment.

From a safe, dry position, note where water appears, whether it is hot, and whether flow changes as the heater operates. Tell the plumber if the unit is gas, electric, solar or a heat pump. A photo can help if it can be taken without approaching the hazard.

For an active leak elsewhere in the home, read how to handle water isolation safely.

If water has reached wiring, see what to do around electrical equipment.

Contact our hot water team to assess a leaking unit or arrange a licensed plumber.