Call our team (07) 5404 9354

Where and in what order should a whole-house filter go?

A filter intended to treat every fixture usually sits upstream of those branches, but the exact arrangement depends on the product and property.

A whole-house filter is usually installed on the property's incoming water line when the aim is to treat multiple fixtures. Exact position and order depend on which water you want treated, the unit's rating and the home's pipe layout. Check the selected model's instructions before planning the connection.

Map the service and branches

A plumber should identify the meter, main isolation valve, any pressure or backflow equipment, and branches to fixtures, irrigation and the water heater. A filter placed after a branch will not treat that branch. To filter all household outlets, it generally needs to be upstream of the branches it should serve.

Do not assume the filter belongs before every water heater. Confirm the product's permitted temperature and service. If only cold drinking water is the goal, a point-of-use system may be more suitable. Check filter sizing and expected flow against the property and technical data.

Choose an accessible position

Leave room to close valves and remove the housing or cartridge without straining pipes. Support the filled unit as required, preserve access to the main stop tap and keep leaks away from electrical equipment and vulnerable finishes. Outdoor units may need weather, sun and impact protection specified by the manufacturer.

Plan cartridge changes and filter maintenance before choosing a location. Check flow direction, pressure limits, water temperature, drain or power needs, bypass design and replacement-part availability.

Do not cut or alter the incoming pressurised pipe. A licensed plumber can confirm branches, applicable backflow requirements and product suitability. Contact our water-filter installation team to assess the service and plan an accessible installation.