There is no one mains-pressure reading that applies to every Queensland home. Pressure at the property connection can vary with the water provider, location, elevation, network demand and operating conditions. The pressure measured at a tap also depends on the private pipework and whether other fixtures are running.
Static pressure is different from flow
Static pressure is measured when outlets are closed; working pressure is measured while water is flowing. A strong-feeling shower does not prove the static pressure is compliant, and a low-flow tap does not necessarily mean the network pressure is low. Blocked aerators, a partly closed valve, a leak or a pressure-reduction valve fault can reduce flow at one or more fixtures.
The NCC includes a general maximum static pressure for building water services, with exceptions where a fixture or appliance needs different pressure. That is a building performance limit, not a promise that your provider supplies that pressure at your boundary or a recommended target for every property.
How to narrow down a pressure problem
Check whether the issue affects hot water, cold water or both, and whether it is limited to one tap or several. Notice if pressure changes at busy times or began after network maintenance. Check your provider’s outage information and compare with a neighbour if appropriate. Do not adjust or dismantle a pressure valve or meter connection.
If pressure is persistently low throughout the home, high enough to cause banging or leaks, or varies sharply, ask a licensed plumber to measure it at suitable points and inspect the private plumbing. Contact the water provider if the issue appears to be on its network side of the connection.
For a pressure-control device, see how a pressure-reducing valve differs from an RPZ.
For low pressure symptoms, read why hot-water flow may be weak.
Contact our plumbing team to check pressure and private pipework.