A thermostat or heating-element fault is possible when an electric storage heater stops heating, but the same symptoms can have other causes. A licensed electrician must inspect internal electrical components.
What the symptoms can tell you
- No hot water: The heater may have lost power or developed a control, thermostat or element fault.
- Lukewarm water: Heating may be incomplete, or a temperature-control or tempering component may need attention.
- Hot water runs out sooner: Recent use, a changed timer setting or reduced heating performance can produce a similar pattern.
- Slow recovery: Note whether the issue follows heavy use or continues after the normal reheating period in the model guide.
Symptoms do not identify which part has failed. If only one outlet is affected, the fixture or mixer may be involved. If every hot outlet is affected, record that pattern for the electrician or plumber.
For broader observations, read what to check when a hot-water system stops working before assuming an element failed.
Safe observations
Without removing covers, note whether the display is on, whether the timer is set and whether the problem is constant or intermittent. A clearly labelled hot-water circuit breaker can be checked visually from a dry, safe switchboard.
Do not open the heater, press a concealed reset, touch terminals or use a multimeter on the element. Rheem's owner guide for its listed electric models assigns thermostat adjustment to a licensed electrical worker; it is not a rule for every heater.
Queensland says electrical work in a home must be done by an electrical contractor. See the Electrical Safety Office licence guidance. Replacing or testing an element or thermostat is not a DIY check.
When to arrange an assessment
Call a licensed electrician if a labelled breaker trips again, heating remains unreliable or you see scorching, damaged wiring or signs of overheating. Keep clear of water near electrical equipment and do not touch wet switches or the heater.
The safe reset guide explains why internal cut-outs must stay closed.
Ask an appropriately licensed professional to diagnose the cause and coordinate any required electrical work. The hot-water repairs service is the relevant next step for a system-level fault.