Both sizes are used, but there is no single size for every sink. The labels often refer to nominal 32 mm (1¼-inch) or 40 mm (1½-inch) connections; check the exact fitting and pipework before choosing a replacement. Which pipe dimension you measure matters.
What do 1¼-inch and 1½-inch labels mean?
These inch labels are commonly paired with metric nominal sizes, rather than giving the measured diameter of every part. A product may identify its waste outlet, thread or trap connection separately, so matching numbers do not prove that two fittings will screw together.
For example, Felton specifies one basin waste for a 32 mm waste pipe or a 40 mm pipe when its supplied adapter is used. That product example does not make all 32 mm and 40 mm wastes interchangeable.
Kitchen basket wastes can have a different outlet again. Oliveri lists a 50 mm outlet on one basket-waste model, while its large top flange sits over the sink opening. The flange, sink hole and outlet are different measurements.
How do you identify the size you need?
Start with the sink and waste model numbers, then check the manufacturer’s technical drawing or installation guide. Confirm whether each listed dimension describes the waste outlet, threaded connection, trap or pipe. The Felton product specification shows how one waste can use a different adapter for a stated pipe size.
- Check the product: Look for a model code or size marking on an accessible part without dismantling fixed pipework.
- Check the connection: Match the outlet, thread, seal and trap requirements in the manufacturer’s instructions.
- Do not force a fit: Similar-looking parts can have different threads or connection types. If the dimensions remain unclear, ask a plumber to identify the assembly.
If the question comes from slow drainage rather than a replacement, check whether the accessible sink P-trap is the issue. A drain’s nominal size alone does not explain a blockage.
Who should replace a sink waste or pipe?
QBCC classifies maintaining, repairing, replacing or removing a plumbing fitting or fixture as minor regulated work, which must be performed by a QBCC licensee. Its regulated plumbing work guidance explains the Queensland categories. It does not mean every replacement requires a permit or notification.
If the size question is really about a sink that keeps blocking, read about recurring kitchen sink clogs. For a recurring drain obstruction, contact us through our blocked-drains service to arrange an assessment. This does not determine the correct fitting without checking the assembly.